Using AC-Out-2 while AC in (grid) is not available (loadshedding)

[mariusm]

@plonkster wrote up about 60% of what you need to do here (but with a different goal).

Driving a Contactor with the Venus Relay

Another way, which will free up that contactor too, is to configure the Multi to ignore its AC input. This is completely untested, but I’ve used this in the past to do something similar. What you do is you set up the General flag assistant to ignore AC-in 1. [Selection_051] Then you set up TWO relay assistants. One of them will drive the relay on, the other will drive it off. If none of the assistants match the conditions you set, the relay stays in its current state. Set these up to read the…